PRESIDENT Light Body 2×50 ml A Silicone วัสดุพิมพ์แบบใช้ปืน สีเขียว CTS-60019938

Mixing time (15ml): 0:15 min

Total working time: 2:00 min

Oral setting time: 3:00 min

The new, high pigmented colours of the PRESIDENT the Original line provide better contrast readability and show every detail, even before the impression is poured. All consistencies offer excellent flow properties in a moist environment. PRESIDENT the Original Light body is characterized by its excellent flow properties and viscosity. As a real all-rounder it is suitable for any impression technique.

Material type

Polyvinylsiloxane, addition-type, surface-activated silicone elastomer.

Cartridge & Tube:

light body – low viscosity

Base: green/Catalyst: light grey

– ISO 4823, Type 3, low consistency

Mixing – Cartridge

1. Remove the safety cap.

2. Activate the lever and press a small amount of material onto a paper towel until equal amounts of base and

catalyst are dispensed from the outlet channel. This

ensures that the plungers are at the same height to

achieve an optimal mix.

3. Wipe off the cartridge outlet channels with paper towels.

4. Attach the appropriate mixing tip to the outlet channel of the cartridge and turn ¼ revolution clockwise

(90°) until it is securely fastened.

5. Place the oral tip on the mixing tip.

6. Press out the impression material with a smooth, constant actuation of the lever. Avoid abrupt movement.

Releasing the lever stops the flow of material

Mixing Tip

After use, clean mixing tip with disinfectant and do not

remove! The mixing tip serves as seal until the next application and prevents contamination of the material. Store

in horizontal position. Only remove the used mixing tip

immediately before the next application, check again for

smooth flow of the impression material and attach new

mixing tip.